Garage Door Safety Inspection is one of the most common calls we get. A technician will explain what is wrong and what it will cost before starting, and test the door before leaving. A full safety check of springs, cables, sensors and auto-reverse.
Signs you need garage door safety inspection
- The door doesn't reverse when it touches an object
- Missing or misaligned photo eyes
- An older opener without photo-eye sensors
- Frayed cables or damaged springs
What usually causes it
- Sensors knocked out of alignment
- Force settings turned up too high
- Openers installed before photo eyes were required (pre-1993)
What you can check yourself
- Place a roll of paper towels where the door closes. The door must reverse on contact.
- Wave something through the photo-eye beam while the door is closing. It should reverse.
Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.
What happens during the visit
- Inspect springs, cables, drums and brackets
- Test the auto-reverse and photo-eye sensors
- Check close force and travel limits
- Inspect the manual release and its labels
- Give you a written report of anything unsafe
How much does garage door safety inspection cost?
What moves the price:
- Door size and weight (single or double, steel or wood)
- Which parts need replacing and whether they are in stock
- Spring type and cycle rating
- Emergency or after-hours timing
These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.
Local garage door safety inspection for Santa Fe, NM
Fine dust in New Mexico packs into roller bearings and the track, so rollers start to drag and squeal well before they are worn out.
Technicians serve all of Santa Fe (ZIP codes 87501, 87502, 87503, 87504, 87505 and more), plus Agua Fria (5.2 mi), Eldorado at Santa Fe (11.1 mi), La Cienega (13.8 mi) and White Rock (17.8 mi). Call (833) 435-8883 to book a visit in Santa Fe.
Garage Door Safety Inspection: frequently asked questions
How much does garage door safety inspection cost in Santa Fe, NM?
Garage Door Safety Inspection typically costs $75-$150 including parts and labor, and usually takes about 45 minutes. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.
Can you do garage door safety inspection the same day?
Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.
Is garage door safety inspection covered by a warranty?
Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty. Ask for the warranty details in writing with your quote.
Are your technicians licensed and insured?
Our technicians are insured, and where New Mexico or Santa Fe requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.
Should I repair or replace my garage door?
A good rule of thumb: if the repair costs more than about 50% of a replacement, or the garage door is near the end of its life, replace it. A garage door typically lasts 15 to 30 years. If several panels are damaged, the door is rusted through or rotted, or parts are discontinued, replacing it is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.